Printer Friendly

mo's corner.

IN THIS EDITION OF mO'S CORNER--OUR REGULAR FEATURE THAT AIMS TO ANSWER COMMONLY ASKED QUESTIONS ABOUT THE MANUFACTURE AND PROCESSING OF PLASTICS--WE LOOK AT WHY COMPRESSED AIR DRYERS ARE BEST SUITED TO DRYING SMALL QUANTITIES OF GRANULATE

Compressed-air dryers fall under the category of dry-air dryers. They use compressed air, expanded to atmospheric pressure, creating dry process air with a low dew point. This air is heated to the required temperature in the dryer. Compressed-air dryers do not require desiccants. The heated air passes through the material, taking on moisture, and is subsequently expelled with the entrained moisture. Compressed-air dryers themselves are comparatively affordable, but compressed air is expensive. As a result, these systems are generally only suitable for drying small quantities of granulate.

Dry, oil- and water-free compressed air is a prerequisite for operation of these systems. The underlying principle of compressed -air dryers is that expanding compressed air causes the dew point to sink. These systems can achieve dew points of -20[degrees]C or lower, depending on the initial dew point of the compressed air.

Air always contains water vapour. When air is compressed, the pressure increases and volume decreases, and the amount of water it can hold is reduced. This is comparable to a sponge--when expanded, it can hold a certain amount of water, but when compressed, the water is squeezed out. Compressing the air raises the temperature, which raises the pressure dew point. The pressure dew point is the temperature to which compressed air can be cooled without causing entrained moisture to condense. If the compressed air cools further in the compressor, the entrained moisture condenses, causing the air 's absolute humidity to sink. The pressure of this air is subsequently reduced prior to it being fed into the production facility's internal compressed-air distribution system, causing the pressure dew point to fall. This pre-expanded air is then fed to the compressed-air dryer, where it is expanded further, then through a heater, and finally through the granulate.

FURTHER QUESTIONS? ASKMO@MOSCORNER.DE

COPYRIGHT 2016 Euro Publishing Consultancy
No portion of this article can be reproduced without the express written permission from the copyright holder.
Copyright 2016 Gale, Cengage Learning. All rights reserved.

Article Details
Printer friendly Cite/link Email Feedback
Publication:British Plastics & Rubber
Date:Nov 1, 2016
Words:336
Previous Article:Renmar becomes UK supplier for EnginPlast granulators.
Next Article:Coperion develops new deflector elbow for prevention of angel hair.

Terms of use | Privacy policy | Copyright © 2020 Farlex, Inc. | Feedback | For webmasters