Printer Friendly

Via-in-pad--why and how: when space or heat constraints force your hand, here's how to implement it.

THERE ARE MANY reasons you shouldn't use via-in-pad. It's not good practice, and those via holes act like little capillary straws and suck solder off the pad or the BGA (FIGURE 1).

That said, there are some applications that may require--or seem to require--via-in-pad. Here are a few examples of why you might need to use via-in-pad:

* There is not enough space on the board.

* It can help with thermal management.

* Trace routing may be easier with via-in-pad when component spacing is tight.

* High-frequency designs benefit from the shortest possible routing to bypass capacitors, which may indicate via-in-pad.

If there is no choice, here are some methods to try when using via-in-pad:

* Have the board fabricator plug the via and then plate copper over it (FIGURE 2). This is our favorite option. It will give all the benefits of via-in-pad without causing problems in assembly. This is really the only via-in-pad method we recommend.

* Use a microvia that goes through only one layer of the board. Although this may be an adequate option, the solder can still wander down into the via, leaving voids.

* Cap the underside of the board with solder mask. This is our least favorite option because sometimes the cap can pop open, and the void may be big enough to still pull too much of the solder off the pad. Never use this method with immersion silver board finish, as outgassing inside the via can corrode the silver surface.

For more information on via--in-pad, check out this video: http://

DUANE BENSON is marketing manager at Screaming Circuits (screamingcircuits. com); dbenson@

COPYRIGHT 2015 UP Media Group, Inc.
No portion of this article can be reproduced without the express written permission from the copyright holder.
Copyright 2015 Gale, Cengage Learning. All rights reserved.

Article Details
Printer friendly Cite/link Email Feedback
Author:Benson, Duane
Publication:Printed Circuit Design & Fab Circuits Assembly
Date:Aug 1, 2015
Previous Article:Establishing an operation in Mexico means evaluating tradeoffs: for manufacturers, Mexico is a balance of promise and complexity.
Next Article:Calculating board weight: while no software is available, there are steps to determine how much is "just enough.".

Terms of use | Privacy policy | Copyright © 2018 Farlex, Inc. | Feedback | For webmasters