Printer Friendly

Articles from Mechanika (November 1, 2015)

1-11 out of 11 article(s)
Title Author Type Words
Addendum modification of spur gears with equalized efficiency at the points where the meshing stars and ends. Alexandru, Antal Tiberiu Report 3920
Damage detection and localization in composite beam structures based on vibration analysis. Khatir, Samir; Belaidi, Idir; Serra, Roger; Wahab, Magd Abdel; Khatir, Tawfiq Report 5089
Data-driven simulations of flank wear of coated cutting tools in hard turning. Cakan, A.; Evrendilek, F.; Ozkaner, V. Report 6212
Heat transfer enhancement in a fin and tube heat exchanger with isosceles vortex generators. Sahel, D.; Benzeguir, R.; Baki, T. Report 4212
Interpretation of parameters in strain energy density bone adaptation equation when applied to topology optimization of inert structures. Nutu, E. 5131
Investigating the effect of passes number on microstructural and mechanical properties of the Al2024/SiC composite produced by friction stir processing. Ghanbari, D.; Asgharani, M. Kasiri; Amini, K. Report 3476
Investigation of cutting tool diameter influencing wire cutting operation accuracy using several matrix configurations. Dundulis, R.; Bortkevicius, R. Report 3636
Numerical modelling of the hydrodynamic behaviour of the couple piston-liner. Soualmia, A.; Bouchetara, M. Report 2457
Optimum design of damped vibration absorber for viscoelastic bladed disk assemblies. Ghaderi, Amir Abdollah; Mohammadzadeh, Alireza; Bahrami, Mansour Nikkhah Report 4197
Practical aspects of increasing workers efficient work time in a high noise level industrial area. Mikalauskas, R.; Volkovas, V. Report 3460
The modelling of operation of the compression ignition engine powered with diesel fuel with LPG admixture. Pulawski, G.; Szpica, D. Report 3350

Terms of use | Copyright © 2017 Farlex, Inc. | Feedback | For webmasters