Printer Friendly

Fujitsu Develops SmartCODEC(TM) Streamlined Image Compression Technology for Automotive Applications; Enables Transmission of Multiple Digital Images on In-Vehicle Networks.

Kawasaki, Japan, Sept 21, 2006 - (JCN Newswire) - Fujitsu Laboratories Limited today announced that it has developed image compression technology for automotive use that complies with the IDB-1394(*1)(ITS Data Bus-1394) standard for in-vehicle digital imaging transmission system

networks. The new technology, SmartCODEC, features a compression rate of one-third (1/3), and a fast compression-decompression time of just 2 to 3 milliseconds that enables compression and multiplex transmission of images to inside the vehicle, such as images from multiple automotive cameras located externally on the vehicle. In addition to assisting facilitation of safer driving through these functions, Fujitsu's new technology also makes it possible to reduce the amount of cable required within the vehicle to achieve fast and high-quality image transmission of multiple images.

Details of the newly-developed technology will be presented at the Institute of Electronics, Information and Communication Engineers (IEICE) conference being held in Kanazawa, Japan from September 19.

There is an increasing need to use multiple video channels in automobiles, such as for video images from multiple surveillance cameras that the driver checks on the monitor, as well as navigation system images and DVDs for passengers watching on rear-seat monitors. Analog signals which have been used thus far required a separate cable to be wired for each channel, a process that has become complicated as the number of channels has increased. This has resulted in demand for a technology capable of multiplex transmission of images on a single in-vehicle LAN.

Technological Challenges

Even with the IDB-1394 image transmission standard (featuring transmission speeds of 400Mbps), bandwidth is insufficient for uncompressed transmission of multiple images, and therefore there is a need for image compression technology. Developing such technology for automotive use has entailed overcoming three challenges: making low-cost packaging for each compression and decompression channel; achieving a transmission delay time of less than 30 milliseconds for surveillance cameras used when the vehicle is being driven; and achieving clear reproduction of letters and lines on images transmitted for car navigation systems. In image compression methods used thus far, such as MPEG, external memory was required for compression-decompression of large-scale integrated circuits (LSIs) thereby leading to higher cost, and in addition, the compression-decompression delay time of several hundred milliseconds had to be overcome. Furthermore, conventional methods mainly used natural images, and there were concerns about poor image quality for car navigation systems, such as broken or indistinct letters.

Newly Developed Technology

The newly-developed SmartCODEC is compression technology dedicated for in-vehicle image transmission. It offers as an industry's first, three features unavailable in conventional technology for in-vehicle image transmission: light weight, minimal delay time and high image quality. In order to lighten the circuitry, the compression ratio was limited to one-third (1/3), and a differential pulse code modulation (DPCM)(*2) scheme featuring simple structures was adopted. In addition, in order to clearly reproduce camera images and the edges of letters and lines on the navigation system, the modulation level is optimized at the pixel unit. By encoding pixels in groups of two, the processing speed was accelerated without increasing the basic clock speed, enabling minimal delay time.

SmartCODEC Specifications

Target images: Natural images, letter and line drawings, YUV 720 x 480 pixels; RGB 800 x 480 pixels, etc.

Processing speed:

Maximum: 60 frames/second; equivalent to RGB 800 x 480 pixels

Minimal delay time:

Compression-decompression time is 2 -3 milliseconds

Design convenience (lightweight circuitry):

Circuit can be enclosed in an IDB -1394 controller LSI; external memory not required

Compression ratio:

Fixed rate of 1/3; (YUV 720 x 480 pixels; transmission rate 55 Mbps for 30 frames/second)


This technology is a lightweight circuit that can be enclosed in the IDB-1394 controller developed by Fujitsu, enabling a one-chip automotive image transmission network and compression-decompression solution. It makes possible low-cost multiplex transmission of images in automobiles with minimal delay time.

Future Developments

This technology is scheduled to be commercialized by Fujitsu Limited in early 2007.


1. IDB-1394 (ITS Data Bus-1394)

A network protocol standard for high-speed in-vehicle multimedia applications, established by the automotive working group of the 1394 Trade Association. Currently, the practical transmission speed for such applications is up to 262 Mbps.

2. DPCM (Differential Pulse Code Modulation):

The value of each pixel of an image generally is related to that of adjacent pixels and tends to have a value close to those adjoining it. In DPCM, taking advantage of this tendency, the values are estimated for pixels adjacent to those targeted for compression, and the degree of difference from the actual pixels is encoded. Since processing is done on the pixel level, it is easy to streamline.

Related Websites

Fujitsu Laboratories Limited:

About Fujitsu Limited

Fujitsu Limited (TSE:6702) is a leading provider of customer-focused IT and communications solutions for the global marketplace. Pace-setting device technologies, highly reliable computing and communications products, and a worldwide corps of systems and services experts uniquely position Fujitsu to deliver comprehensive solutions that open up infinite possibilities for its customers' success. Headquartered in Tokyo, Fujitsu Limited reported consolidated revenues of about 4.8 trillion yen (US$40.6 billion) for the fiscal year ended March 31, 2006. See for further information.

About Fujitsu Laboratories Ltd.

Founded in 1968 as a wholly owned subsidiary of Fujitsu Limited, Fujitsu Laboratories Limited is one of the premier research centers in the world. With a global network of laboratories in Japan, China, the United States and Europe, the organization conducts a wide range of basic and applied research in the areas of Multimedia, Personal Systems, Networks, Peripherals, Advanced Materials and Electronic Devices. For more information, please see:

Source: Fujitsu Laboratories Ltd.

Public and Investor Relations
Fujitsu Limited

Technical Contact:
ITS Research Center
Fujitsu Laboratories Limited
Tel: +81-44-754-2577

Copyright [c] 2006 JCN Newswire. All rights reserved. A division of Japan Corporate News Network K.K.
COPYRIGHT 2006 Japan Corporate News Network K.K.
No portion of this article can be reproduced without the express written permission from the copyright holder.
Copyright 2006, Gale Group. All rights reserved. Gale Group is a Thomson Corporation Company.

Article Details
Printer friendly Cite/link Email Feedback
Publication:JCN Newswires
Date:Sep 21, 2006
Previous Article:MHI Receives Order for Six M501G Gas Turbines.
Next Article:Dainippon Sumitomo Pharma 2006 Annual Report to Shareholders, 'True Quality, Our New Beginning'.

Related Articles
NEC Develops Mobile Phone Digital Document Viewer for Quick & High Quality Display of Mail Attachments Anywhere, Anytime.
Fujitsu Laboritories Develops High-quality, Low-power H.264 Standard Video Compression Technology.
Fujitsu Launches New Image-Processing Chips for Compact Digital Cameras with Video.
Fujitsu Launches Industry's First One-Chip LSI for Full HD H.264 Video Processing with Embedded Memory.

Terms of use | Privacy policy | Copyright © 2020 Farlex, Inc. | Feedback | For webmasters