Printer Friendly

Cheese board, bread board, whatever-board.

Cheese board, bread board, whatever-board

If you can drill a hole or make a straight saw cut, you can make a custom inlaid cutting-serving board of your own design. We used scraps of hardwood, water-resistant wood glue, and a variety of dowels to make the three boards pictured at right.

Each takes less than an hour to complete (plus glue-drying time), so you could make several to give as gifts. Cost of materials ranges from $3 to $10, depending on choice of wood and doweling (check with hardwood dealers to find maple, walnut, or oak doweling).

Make round motifs with different-size dowels in drilled holes; for stripes, set ripped hardwood strips into sawn grooves. Or combine both techniques. After sanding boards, rub with mineral oil.

Photo: Drill holes for dowels using drill guide (shown), drill press, or a steady hand. Success with twist, auger, or spade bits depends on wood density, drilling skills. Note lapped dowels already in place

Photo: Tap dowel pegs coated with glue into glue-coated holes. Position end grain for desired effect. Dowels should be flush with board bottom. Quickly wipe off excess glue

Photo: Saw off dowel pegs using any fine-tooth saw (shown is offset backsaw) when glue has dried. While cutting, take care not to mar board or splinter doweling below board top. Fill unwanted voids with glue and sawdust

Photo: Sand with a portable sander to make everything level and reveal grain pattern of dowel ends. To prevent ends from scorching, keep the sander moving and don't press too hard

Photo: Cut a shallow saw kerf with a table saw (shown) or a radial-arm or hand-held circular saw. For wider grooves, use a dado blade. Note that one corner of wood is left square so miter gauge can be used for angles

Photo: Lay kerf-wide ripped strips of wood into glue-lined grooves. Use a generous coat of glue; tap strips into place. When dry, use a sander to sand strips flush. Cut board to shape with jig, band, or saber saw; hand sand

Photo: Dowel dots punctuate maple cutting board. The largest dowel is 1-inch maple, lapped by 3/4-inch walnut, flanked by 1/2-inch oak, then 1/4-inch walnut

Photo: Stripes of maple and purpleheart angle across this round teak cheeseboard

Photo: Ambassador's ribbon of mahogany and 1 3/4-inch oak round distinguish this board of richly toned purpleheart
COPYRIGHT 1986 Sunset Publishing Corp.
No portion of this article can be reproduced without the express written permission from the copyright holder.
Copyright 1986 Gale, Cengage Learning. All rights reserved.

Article Details
Printer friendly Cite/link Email Feedback
Publication:Sunset
Date:Dec 1, 1986
Words:396
Previous Article:Hello winter, good-by holiday bustle; here are San Francisco Bay Area escapes into the countryside.
Next Article:It wouldn't Christmastime without.
Topics:


Related Articles
For a quick appetizer, melted brie in a hollowed-out loaf.
From Russia, Germany, and France come three hearty (and unusual) peasant breads.
Beastly bread and jungle toast.
Eating In: Cheese for all Tastes; UNTIL I moved to Wales, a few years ago, I had never heard of Pant-ysgawn goat cheese, but since then wherever I...
HIGH DESIGN RULES AT MACEF.
It's Not Your Mother's Ham & Cheese.
Fall in Love With Wisconsin Gouda.
NO_HEADLINE.
RAREBIT AND SMOKED BREAD.
Welsh cheeses win minister's praise.

Terms of use | Copyright © 2017 Farlex, Inc. | Feedback | For webmasters