Printer Friendly

Build the perfect chicken coop: with this unique design, anyone can keep a few chickens, even in a small backyards.

[ILLUSTRATION OMITTED]

Chickens are every bit as fun and easy to care for as dogs or cats, plus they provide a steady supply of fresh eggs. The biggest challenge is keeping the birds safe from predators and, at the same time, allowing them to enjoy a natural diet of grains, greens and insects.

Most poultry predators roam at night--raccoons, coyotes, owls and such. But hawks and some dogs have been known to attack flee-ranging birds during the day, especially when there are no humans or guard dogs at home to chase them away. You could keep your birds safe inside a fully enclosed conventional coop, but then they wouldn't be able to forage for their natural diet, which results in the best-tasting and most nutritious eggs. Portable electric mesh fencing can serve as daytime protection in some locations, but not against hawks. Plus, you'll still need shelter for the hens to sleep in.

To make it easy for anyone to raise a few chickens on pasture, I set out to create a coop that would be secure, low-cost, easy to build, light enough to move easily and scaled to fit well even in small backyards. After working through several prototypes, this design meets all the criteria. It's intended for three or four hens, costs only about $100 in materials and can be assembled in a few hours from standard welded wire fencing. A barn-style plastic doghouse serves as a henhouse that sits inside the wire pen. The pen and house combo is lightweight and easy to pull to a new location every few days, so you can keep your birds safe and still let them enjoy clean, fresh pasture (or set them over garden beds to help fertilize and control pests).

[ILLUSTRATION OMITTED]

To make this PORTABLE MINI-COOP, head to your local hardware or farm store and get the following items:

* BARN-STYLE DOGHOUSE: The larger the better, but be sure you get the 1-inch-by-2-inch-mesh wire fencing for the pen's side walls (see below) in a height that's at least as tall as the doghouse you choose.

[ILLUSTRATIONS OMITTED]

* 1-INCH-BY-2-INCH-MESH WELDED WIRE FENCING, as tall as the doghouse--38 feet is enough to make the sides and doors for one 3-foot-by-10-foot pen. This fencing is stiff enough to make sides that support the top and produce a sturdy rectangular wire pen.

* 25 FEET OF 2-INCH-BY-4-INCH-MESH WELDED WIRE, 36 inches wide (or 48 inches for a wider pen--see Step 2); this is for the coop's top and bottom panels. You could use 1-inch-by-2-inch mesh throughout, but the 2-inch-by-4-inch is sufficient, plus it's lighter and less expensive.

* TWO OR THREE BOXES OF "HOG RINGS" and the special pliers to pinch them closed. I discovered these nifty fasteners at a Tractor Supply Co. store. They are designed to be pierced into pigs' noses to discourage them from rooting, but they're perfect for quickly attaching the walls, top and bottom to form a lightweight all-wire (no wood!) pen. Aluminum J-clips used for constructing rabbit hutches will also work well--be sure to get the matching pliers.

* If you don't already have WIRE CUTTERS OR A SMALL BOLT CUTTER, buy a tool that will let you easily cut the wire fencing.

STEP 1: Bend the l-inch-by-2-inch-mesh fencing to make the sides of the 3-foot-by-10-foot pen.

STEP 2: Cut an 11-foot length of the 2-inch-by-4-inch-mesh wire, fold 6 inches under on each end (to provide extra stiffness) so you have a section that is 10 feet long. Using the hog rings every 4 to 6 inches, attach the 2-inch-by-4-inch wire section to form a top for the 3-foot-by-10-foot wire rectangle. (1 also made one test pen that was 4 feet wide, rather than 3 feet. To prevent the wider top section from sagging, I slipped two l-inch-by-2-inch wooden "beams" through the top slots in the side walls.)

STEP 3: Make another 10-foot section as described above, flip the pen over and install the second section.

STEP 4: To make the door openings--one at one end so you can gather the eggs from the henhouse and slide the house out for cleaning, and one at the other end to allow you to tend the birds' food and water containers--cut sections of wire out of each end of the pen to form openings tall and wide enough for the house to slide in and out easily. Bend back all the sharp wire ends.

STEP 5: Make the doors--two 3-foot-by-1 1/2-foot flaps of the 1-inch-by-2-inch-mesh fencing that hinge up from the bottom and down from the top (use the hog rings to make the "hinges"); the top and bottom flaps will overlap 6 inches m the middle. This door design lets you open only the top flap to reach in for eggs, or open both the top and bottom flaps if you need to slide the coop out. Use bungee cords or whatever fasteners you have on hand to secure the door flaps.

STEP 6: To adapt the barn-style doghouse (sold in various sizes at most hardware, farm supply and home improvement stores), first file off the tabs that hold the roof section to the bottom (a wood rasp works well) so you can easily lift off the roof when you need to change the bedding. Then install a 1-inch-by-2-inch board as a roost at the top edge of the bottom section, and attach a thin plywood "wall" to a second crosspiece toward the back of the coop, with a hole cut in it so the hens can lay their eggs in the "back room" (they like a dark, cozy spot). Put the top section of the doghouse onto the bottom backwards, so you have a large opening in the front and a smaller, higher opening facing the back. This way, you can reach into the back opening to gather eggs.

If you want two coops, you could economize by buying just one doghouse and using both the bottom and top sections as the roofs for two houses, each set onto rectangles made of lightweight, rot-resistant cedar boards.

STEP 7: Finally, trace the shape of the front and back henhouse openings, cut plywood doors to fit and hinge them to the openings. I made the front door hinge downward and attached a cord to the top edge so I can just pull the cord up to close the door; and I put a small snap fastener on the end of the cord so opening or closing the door takes about five seconds! I thought the wire pens would be fully predator-proof and the birds would not need to be locked inside the house at night, but I learned the hard way that gangs of raccoons can manage to scare young birds out of the house, then reach through the wire and kill them! So, even though the birds naturally go into the house at night to roost, it's still a good idea to close the door each evening.

Mother Earth News Editor in Chief Cheryl Long looks forward to a day when there are chickens in every backyard. She keeps her Welsummer and Jersey Giant hens in the portable pens she designed for this article
COPYRIGHT 2007 Ogden Publications, Inc.
No portion of this article can be reproduced without the express written permission from the copyright holder.
Copyright 2007 Gale, Cengage Learning. All rights reserved.

Article Details
Printer friendly Cite/link Email Feedback
Title Annotation:In The Shop
Author:Long, Cheryl
Publication:Grit
Geographic Code:1USA
Date:Sep 1, 2007
Words:1194
Previous Article:Coexisting with coyotes: coyotes are more prevalent in urban areas as their primary habitat falls to development.
Next Article:Trees for tomorrow.
Topics:

Terms of use | Privacy policy | Copyright © 2018 Farlex, Inc. | Feedback | For webmasters