Printer Friendly

Beef up entry door security.

You can spend hundreds on a fancy "pick-proof" dead bolt for your entry door. But you're kidding yourself if you think that'll stop most burglars. The truth is, most don't know how to pick a lock. They gain entry with one really well-placed kick or body slam that splits the doorjamb (and often the door as well), and they walk right in. You can stop burglars in their tracks by beefing up your door and jamb with reinforcing hardware. The components cost about $120 and take about an hour to install. Here's how to do it.

Start by measuring the entry door thickness and the spacing between the entry knob and the dead bolt cylinder. Then buy either a single or a double wrap-around door reinforcement plate kit (less than $20 at any home center or hardware store) and four 1-1/2-in.-long stainless steel wood screws. Then get a doorjamb reinforcement kit (StrikeMaster II is one brand; $100 from homedepot.com or amazon.com).

Remove the entry knob and dead bolt cylinder. Then remove the dead bolt and latch and toss the short screws. Install the wrap-around door reinforcement plate and reinstall the latch and dead bolt plates using the longer stainless steel screws (Photo 1). Next, mark both the latch and the dead bolt "centers" on the strike side of the jamb (Photo 2). Remove the latch and strike plates and weather stripping from the jamb. But leave any weather stripping that's attached to the door stop. Then align the reinforcement plate, predrill a few mounting holes and add screws (Photo 3). Check the reinforcement plate alignment before snugging the screws by hand. Do not overtighten.

If the prescored dead bolt knockout lines up with the marking along the jamb, remove it and finish installing the remaining screws, If it doesn't line up, drill a new dead bolt hole with a 3/4-in. bimetal hole saw. Finally, replace two screws in each hinge with the longer screws provided in the kit.

[ILLUSTRATION OMITTED]

1 REINFORCE THE DOOR

Slide the reinforcement plate onto the door and insert the dead bolt and dead latch. Secure them with l-l/2-in.-long stainless steel screws. Then secure the plate to the door with the matching screws from the kit.

[ILLUSTRATION OMITTED]

2 MARK THE LATCH AND BOLT CENTERS

Extend the dead bolt slightly and close the door. Mark the center of the bolt on the edge of the doorjamb with a pencil. Then mark the center of the latch on the jamb.

3 ATTACH A JAMB REINFORCEMENT PLATE

[ILLUSTRATION OMITTED]

Extend the pencil marks to the door stop. Then line up the center of the latch alignment hole on the reinforcement plate with the centerline mark. Slide the plate into place. Predrill two holes and run the supplied screws almost all the way into the jamb with your drill. Stop before they're seated or you'll bow the door frame.

editors@thefamilyhandyman.com

COPYRIGHT 2011 Home Service Publications, Inc.
No portion of this article can be reproduced without the express written permission from the copyright holder.
Copyright 2011 Gale, Cengage Learning. All rights reserved.

Article Details
Printer friendly Cite/link Email Feedback
Title Annotation:HOME CARE& REPAIR
Author:Muscoplat, Rick
Publication:The Family Handyman
Date:Jul 1, 2011
Words:490
Previous Article:Centuries-old natural wood finisher.
Next Article:Sharpen your shovel.
Topics:

Terms of use | Privacy policy | Copyright © 2019 Farlex, Inc. | Feedback | For webmasters