Senpai DC/DC Converters Deliver up to 600W/cubic inch; 8A of Output Current in Smallest Industry-Standard POL Footprints.SAN JOSE San Jose, city, United States San Jose (sănəzā`, săn hōzā`), city (1990 pop. 782,248), seat of Santa Clara co., W central Calif.; founded 1777, inc. 1850. , Calif. -- FDK FDK Frederick, MD (airport code) FDK From Data to Knowledge (University of Helsinki) FDK Function Display Key FDK Frequency Difference Keying FDK Frame Developer'S Kit FDK Federated Simulations Development Kit Corporation (TOKYO:6955) announced the latest products in their Senpai Series of non-isolated point of load (POL) converters. Delivering 8 Amperes (A) in the smallest industry-standard footprints, the FPMR FPMR Frente Patriótico Manuel RodrÃguez (Manual Rodriguez Patriotic Front) FPMR Federal Property Management Regulation FPMR Functional Performance Manpower Review FPMR Federal Project Management Regulation 12TR7508NA and the FPMR12SR7508NA converters provide 60% higher output current than other available POL converters in the same input voltage range. The power density of up to 600Watts/cubic inch sets a new standard for power delivery in this footprint and pin-out. These dc/dc converters are designed for Intermediate Bus Architecture (IBA IBA abbr. International Bar Association IBA (in Britain) Independent Broadcasting Authority IBA n abbr (Brit) (= Independent Broadcasting Authority ) and Distributed Power Architecture (DPA DPA - Data Protection Act ) applications that require high efficiency, tight regulation, and high reliability in elevated temperature environments with low airflow. The FPMR12TR7508NA converter is offered in a 0.9x0.4x0.195 inch (22.9x10.2x4.95mm) SIP package, and the FPMR12SR7508NA converter is offered in a 0.8x0.45x0.211 inch (20.3x11.4x5.35mm) SMD (1) (Storage Module Device) A high-performance hard disk interface used with minis and mainframes that transfers data in the 1-4 MBytes/sec range (SMD-E provides highest rate). See hard disk. package. They operate from a wide input voltage range of 6.0 Volts - 14 Volts (V) DC, and provide programmable and fixed output voltages in the range of 0.75V - 5.5V DC. Both products feature remote ON/OFF, over-current and over-temperature protection, and output voltage adjust, and are compatible with standard trim equations. These Senpai Series converters deliver full-rated output current, with little or no derating Derating is the technique employed in power electrical and electronic devices wherein the devices are operated at less than their rated maximum power dissipation taking into consideration the case/body temperature, ambient temperature and the type of cooling mechanism used. , at high ambient temperatures Outside temperature at any given altitude, preferably expressed in degrees centigrade. , with minimal airflow. Under natural convection cooling, the FPMR12TR7508NA and the FPMR12SR7508NA provide the full-rated current of 8A in ambient temperatures up to 85 degrees Celsius and 70 degrees Celsius, respectively. This best-in-class thermal performance results from electrical, thermal, and packaging design that is optimized for high density circuit card conditions. "These latest additions to the Senpai Series reflect our ongoing commitment to providing high performance, high quality, and cost effective dc/dc converter products to the marketplace," said Katsuya Fujii, president and CEO (1) (Chief Executive Officer) The highest individual in command of an organization. Typically the president of the company, the CEO reports to the Chairman of the Board. of FDK America, Inc. "By reducing the space needed for on-board On board usually means to be traveling on some vehicle. For example, Baby On Board. Compare with overboard. Metaphorically, the term on-board is often used to refer to some piece of technology that is integrated in a moving vehicle, for example: "The 8A converters of the Senpai Series set new standards for point of load power delivery," said Dr. Apurba Roy, founder and former CEO of di/dt, Inc. "They provide significantly higher output power than other POL converters in these standard footprints, are able to operate with no derating in high temperature and low airflow environments, are manufactured in Japan to FDK's high quality standards, and yet are extremely cost competitive." All Senpai Series products are RoHS compliant. They are manufactured using FDK's state-of-the-art in-house manufacturing processes and systems. In quantities of 1,000 pieces, the FPMR12TR7508NA and the FPMR12SR7508NA converters are priced at $8.00. Samples are available now. For more information, call 408-432-8331, or visit our website at www.fdkamerica.com. Photos and datasheets available at http://www.fdkamerica.com/s_ddconv/release/re20060517.htm. About FDK America, Inc. FDK AMERICA, INC. is the US-based sales and customer support arm of FDK Corporation. Established in 1979, FDK AMERICA is part of the global FDK group whose headquarters are based in Tokyo, Japan. FDK Corporation (TOKYO:6955) designs and manufactures a comprehensive line of electronic components and batteries. FDK's experience with electronic materials, circuits, and high-density mounting technologies has been cultivated for over fifty years and enables FDK to supply highly innovative, quality products to customers worldwide. |
|
||||||||||||||
Printer friendly
Cite/link
Email
Feedback
Reader Opinion