Articles from Polymer Engineering and Science (December 1, 2005)

Title	Author	Type	Words
Cure kinetics and modeling of an epoxy resin cross-linked in the presence of two different diamine hardeners.	Lahlali, D.; Naffakh, M.; Dumon, M.		3466
Dielectric properties of an epoxy-amine system at a high microwave frequency.	Zong, Liming; Zhou, Shuangjie; Sgriccia, Nikki; Hawley, Martin C.; Sun, Rensheng; Kempel, Leo C.		2606
Effect of C[O.sub.2] sorption and desorption on the creep response of polycarbonate.	Pasricha, Arun; Wing, Gregory; Kumar, Vipin; Tuttle, Mark; Seeler, Karl		3227
Effects of injection-molding conditions on the gloss and color of pigmented polypropylene.	Pisciotti, Francesco; Boldizar, Antal; Rigdahl, Mikael; Arino, Ingrid		6718
Fabrication and characterization of biodegradable poly(lactic acid)/layered silicate nanocomposites.	Wu, Tzong-Ming; Chiang, Ming-Feng		3067
Hydrocarbon stability of perfluorinated polyether rubbers at elevated temperatures.	Bigg, D.M.; Heater, K.J.; Skidmore, T.L.; Arai, M.		5109
Injection molding-induced morphology of thermoplastic polymer blends.	Zhong, Gan-Ji; Li, Zhong-Ming		7722
Investigation of odd-odd nylons based on undecanedioic acid. 2: crystal structures.	Cui, Xiaowen; Li, Weihua; Yan, Deyue		3711
Minimum wet thickness for double-layer slide-slot coating of poly(vinyl-alcohol) solutions.	Lin, Yao-Nan; Liu, Ta-Jo; Hwang, Shyh-Jye		4750
Morphology, viscoelastic properties, and mechanical behavior of epoxy resin modified with hydroxyl-terminated poly(ether ether ketone) oligomer with pendent tert-butyl groups.	Francis, Bejoy; Rao, V. Lakshmana; Ramaswamy, R.; Jose, Seno; Thomas, Sabu; Raju, K.V.S.N.		5552
New description of viscoelasticity that can be applied to mechanical properties such as constant strain rate, creep, and stress relaxation analysis.	Sudduth, Richard D.		2458
Properties of polypropylene/aluminum trihydroxide composites containing nanosized organoclay.	Ristolainen, Noora; Hippi, Ulla; Seppala, Jukka; Nykanen, Antti; Ruokolainen, Janne		3975
The effect of the volume fraction of dispersed phase on toughness of injection molded polypropylene blended with SEBS, SEPS, and SEP.	Matsuda, Yushi; Hara, Masao; Mano, Tsuyoshi; Okamoto, Kenzo; Ishikawa, Masaru		4155
Ultrasonic improvement of weld line strength of injection-molded polystyrene and polystyrene/polyethylene blend parts.	Lu, Chang; Yu, Xiaofeng; Guo, Shaoyun		2947
Weld lines in nylon 6 melt-blended nanocomposites.	Tung, J.; Simon, G.P.; Edward, G.H.		4824