New LLDPE Runs on HMW-HDPE Film Lines.A new hexene LLDPE LLDPE Linear Low Density Polyethylene is designed to process on HMW-HDPE blown-film lines. Petrothene GA 605 from Equistar Chemicals, Houston, is a 0.6-MI, 0.930-g/cc resin with 1200 ppm (Pages Per Minute) The measurement of printer speed. See gppm. PPM - Portable Pixmap of slip additive, 5000 ppm of antiblock, and 1000 ppm of processing aid. It has dart impact strength of 150 g, tensile strength tensile strength Ratio of the maximum load a material can support without fracture when being stretched to the original area of a cross section of the material. When stresses less than the tensile strength are removed, a material completely or partially returns to its of 8700 psi, haze of 20%, and gloss of 40. It can produce monolayer mon·o·lay·er n. 1. A film or layer one molecule thick formed at the interface between water and either oil or air by a substance such as a partially esterified fatty acid that contains both hydrophobic and hydrophilic groups in the same blown film that exhibits a good balance of stiffness and strength. However, it is also designed for coextrusion as a surface layer to enhance the clarity gloss, printability, and heat sealing of HMW-HDPE. According to according to prep. 1. As stated or indicated by; on the authority of: according to historians. 2. In keeping with: according to instructions. 3. Equistar, there is a trend among HMW-HDPE film converters to adapt their existing extrusion systems (with grooved-feed, short-barreled extruders) to run resins other than HMW-HDPE. GA 605 LLDPE with its higher density and lower MI is a response to this trend. Its additives are said to optimize processing in a grooved-feed HMW-HDPE extruder. Applications include retail bags, consumer can liners, commercial and industrial packaging and food packages. |
|
||||||||||||||||||||
Printer friendly
Cite/link
Email
Feedback
Reader Opinion