Intersil Releases Wide Input Range Dual PWM Controller to Power DDR Memory, Graphics and Chip Sets in Notebook PCs.

Business Editors/High-Tech Writers

MILPITAS, Calif.--(BUSINESS WIRE)--April 19, 2004

Intersil Corporation (Nasdaq:ISIL):

-- Low Total Solution Cost for Notebook PC System Voltages

-- Direct Voltage Conversion from Adaptor, Battery or System

Rails

Intersil Corporation (Nasdaq:ISIL), a world leader in the design and manufacture of high performance analog solutions, today announced the release of the ISL6227, a new dual PWM controller IC designed to power DDR memory, graphics, chip sets and other systems in notebook PCs. Its wide input voltage range capability allows for voltage conversion directly from an AC/DC adaptor, from the Li-ion battery pack or from system 5 V or 3.3 V buses. The ISL6227 is a pin-compatible performance upgrade for the ISL6225.

"The ISL6227 is an advanced and highly integrated dual PWM controller that reduces board space, bill-of-materials and manufacturing costs to meet notebook power needs as compared to most legacy solutions," said Dean Henderson, Director of Intersil's Notebook Power Products. "This new controller delivers high performance for notebook system power requirements including the powering of DDR1 and DDR2 memory. It provides on-chip tracking, a buffered reference output and current sink and source capability for DDR memory termination."

The ISL6227 dual PWM controller delivers highly efficient and precise voltage regulation. Automatic mode transition of constant-frequency synchronous rectification at heavy load, and hysteretic (HYS) diode-emulation at light load, assure high efficiency over a wide range of conditions. The HYS mode of operation can be disabled separately on each PWM converter if constant-frequency continuous-conduction operation is desired for all load levels. Efficiency is further enhanced by using the lower MOSFET's RDS(ON) as the current sense element.

Voltage feed-forward ramp modulation, current-mode control, and internal feedback compensation provide fast response to input voltage and load transients. Input current ripple is minimized through the use of a channel-to-channel PWM phase shift of 0, 90, or 180 degrees and is determined by theVin pin voltage and the status of the DDR pin.

The ISL6227 can control two independent output voltages adjustable from 0.9 V to 5.5 V. By activating the DDR pin, the ISL6227 is transformed into a complete DDR memory power supply solution. In DDR mode, the channel 2 (CH2) output voltage (VTT) tracks at half the channel 1 (CH1) output voltage (VDDQ). The CH2 output can both source and sink current, an essential power supply feature for DDR memory. The reference voltage (VREF) required by DDR memory is generated as well.

In dual power supply applications, the ISL6227 monitors the output voltage of both CH1 and CH2. An independent power good (PGOOD) signal is asserted for each channel after the soft-start sequence has completed and the output voltage is within the PGOOD window. In the DDR mode, CH1 generates the only PGOOD signal.

Built-in over-voltage protection prevents the output from going above 115 percent of the set point by holding the lower MOSFET on and the upper MOSFET off. When the output voltage re-enters regulation, PGOOD goes HIGH and normal operation automatically resumes. After the soft-start sequence has completed, undervoltage protection latches the offending channel off if the output drops below 75 percent of its set point value. Adjustable over-current protection monitors the voltage drop across the RDS(ON) of the lower MOSFET. If more precise current-sensing is required, an external current sense resistor can be used.

ISL6227 Technical Summary

-- Provides two precise voltage outputs in the 0.9 to 5.5 V range

-- Cost-saving high-performance solution for DDR memory,

graphics, chip sets and system

-- Accepts input from AC/DC adaptors/chargers, 5 to 24 V battery

or from 3.3/5 V buses

-- Complete DDR1 and DDR2 memory power solution

-- VTT tracks VDDQ/2 without additional external tracking

circuitry

-- Buffered reference voltage output

-- Current source and sink for VTT

-- Synchronous-buck mode for heavy loads and hysteretic mode for

light loads

-- Hysteretic diode emulation mode can be disabled

-- Choice of loss-less RDS(ON) current sensing or external

current-sense resistor

-- Excellent dynamic response with voltage feed-forward and

current mode control accommodating wide range LC filter

selections

-- Power good indicator for each channel

-- Over-voltage, under-voltage and over-current protection for

each channel

-- 28-lead SSOP package - Pb-free version available

-- Pin-compatible performance upgrade for the ISL6225

ISL6227 Pricing and Availability

The ISL6227CA is available now. The suggested resale price for quantities of 100 to 999 units is $2.37 on tape and reel in the 28-lead SSOP package.

About Intersil

Intersil Corporation, a NASDAQ 100 Index company, is a leader in the design and manufacture of high performance analog semiconductors. The company's products address three of the industry's fastest growing markets: flat panel displays, optical storage (CD and DVD recordable) and power management. Intersil products include power management devices for battery management, hot-swap and hot-plug controllers, linear regulators, supervisory ICs, switching DC-DC regulators and power MOSFET drivers; optical storage laser diode drivers; DSL line drivers; video and high performance operational amplifiers; data converters; interface ICs; analog switches and multiplexers; crosspoint switches; voice-over-IP devices; and ICs for military, space and rad-hard applications. For more information about Intersil or to find out how to become a member of our winning team, visit the company's web site and career page at http://www.intersil.com.

This release may include "forward looking statements" that are subject to risks and uncertainties. For information identifying economic, political, climatic, currency, regulatory, technological, competitive and some other important factors that could cause actual results to differ materially from those anticipated in the forward looking statements, see Intersil's Safe Harbor Forward Looking Statement disclaimer found at http://www.intersil.com/legal.asp, as well as Intersil's SEC filings as updated from time to time, found at http://www.sec.gov.

All trademarks mentioned are the property of their respective owners.