Printer Friendly

Publications in Construction and materials industries

1-9 out of 9 publication(s)
Publication Audience Format Latest Issue Articles
ASHRAE Transactions Academic Magazine/Journal Jan 1, 2014
  • Evaluation of seasonal performance improvements in a 3-ton air-conditioning heat pump system using a novel design of integrated electronic expansion...
  • Options for determining marginal primary energy and greenhouse gas emission factors.
  • Estimation of cooling energy demand and carbon emissions from urban buildings using a quasi-dynamic model.
  • Changes in ASHRAE standard 169: implications for energy codes and standards.
  • Solar water heating system with phase change materials and carbon nanotube.
  • Typical hot water draw patterns based on field data.
  • Designing hydronic systems to maximize efficiency and response.
  • Conversion of an existing transverse ventilation system to a longitudinal system using a Saccardo Nozzle.
  • Upgrading an existing tunnel ventilation systems with jet fans and zoned transverse ventilation.
  • Working with constraints: an interstate tunnel retrofit.
  • Experimental evaluation of the thermal comfort in an occupied office under transient conditions using a hydronic radiant ceiling cooling system.
  • Energy analysis of C[O.sub.2]-based demand controlled ventilation and economizer for air source heat pump in schools.
  • Indoor air environment and heat recovery ventilation in a passive school building: a case study for winter condition.
  • Pre-cooling chilled water return replacing yesterday's strainer cycle.
  • Dynamic model of a refrigeration system with active thermal energy storage.
  • An exergy-based algorithm for optimizing CHP systems in health facilities.
  • Comparison of measured and predicted ground source heat pump system operations for the ASHRAE Headquarters Building.
  • The measured impacts of building enclosure renewals on HVAC system performance and energy efficiency.
  • Predicting envelope leakage in multifamily buildings.
  • Reducing office plug loads through simple and inexpensive advanced power strips.
  • 1274
    Cement Americas Trade Magazine/Journal Sep 1, 2010
    Concrete Products Trade Magazine/Journal Sep 1, 2014
    Concrete Products (Online Exclusive) Trade Magazine/Journal Nov 1, 2010
    Construction & Demolition Recycling Trade Magazine/Journal Nov 1, 2007
    HVAC & R Research Academic Magazine/Journal Aug 1, 2012
  • Development of a calibration reference device for use with test standard ANSI/ASHRAE 52.2-2007 (RP-1466).
  • Impact of geometry of a sedentary occupant simulator on the generated thermal plume: experimental investigation.
  • Spatial distribution of fluence rate from upper-room ultraviolet germicidal irradiation: experimental validation of a computer-aided design tool.
  • Equivalence in ventilation and indoor air quality.
  • Are intelligent agents the key to optimizing building HVAC system performance?
  • A simplified combined displacement and personalized ventilation model.
  • Flow pattern and thermal comfort in office environment with active chilled beams.
  • The aerodynamic behavior of respiratory aerosols within a general patient room.
  • Numerical comparison between energy and comfort performances of radiant heating and cooling systems versus air systems.
  • A new scale for representing the level of reaction in indoor air as affected by ventilation and source.
  • Field evaluation of thermal comfort and indoor environment quality for a hospital in a hot and humid climate.
  • Appraising healthcare ventilation design from combined infection control and energy perspectives.
  • Effects of various indoor environmental factors on the decay of chlorine dioxide gas concentration: implications of its use against pandemic...
  • Ultraviolet irradiance measurement and modeling for evaluating the effectiveness of in-duct ultraviolet germicidal irradiation devices.
  • Identifying index (source) patient location of SARS transmission in a hospital ward.
  • Exposure of health care workers and occupants to coughed airborne pathogens in a double-bed hospital patient room with overhead mixing ventilation.
  • Measurement of the concentration and size of aerosol particles and identification of the sources in orthopedic surgeries.
  • Co-occupant's exposure of expiratory droplets--effects of mouth coverings.
  • Assessment of the mixing air delivery system ability to protect occupants from the airborne infectious disease transmission using Wells-Riley...
  • Airborne cross-infection risk between two people standing in surroundings with a vertical temperature gradient.
  • 386
    Infrastructure Today Trade Magazine/Journal Feb 1, 2010
    TendersInfo Trade Newswire Jul 28, 2010
    Underground Construction Trade Magazine/Journal Jul 1, 2014

    Terms of use | Copyright © 2014 Farlex, Inc. | Feedback | For webmasters